MAPLUS HP3 RED HIGH FLUOPARAFFIN WAX

HP3 RED

Packaging format
- Code MW0903N - 50gr
- Code MW0913N - 250gr
- Code MW0923N - 1kg
All snow types
–7°/–3°C
60/100%
130/140°C
DESCRIPTION

Solid paraffin with a high fluorine content for competitive use as an end product or as a base product for overlaying FP4 perfluorinated waxes. To be used for snow from -7° to -3°C. Air humidity from 60% to 100%. In the case of new or stored abrasive snow mixed with artificial snow or hard spring snow mix with HP3 GREEN or with LP2 GREEN if humidity is lower. Hot application with a waxing iron.
APPLICATION METHODOLOGY

GENERAL PRINCIPLES

The application of hydrocarbon paraffins (Med or Soft Racing Base or BP1), fluorinated hydrocarbon paraffins (LP2 or HP3) and perfluorinated waxes FP4 allows certain overlaps based on the following chemical affinities:
Hydrocarbon paraffin alone (Med or Soft Racing Base or BP1) or mixed with other hydrocarbon paraffins;
Fluorinated hydrocarbon paraffin alone (LP2 or HP3) or mixed with other hydrocarbon paraffins;
Perfluorinated wax FP4 on its own or mixed with other perfluorinated waxes but in any case superimposed on fluorinated hydrocarbon paraffin (LP2 or HP3) .
The direction in waxing operations must always be from the tip to the tail of the tool.
Race waxing can be performed hot or cold depending on the physical state of the products and the experience of the skiman.

APPLICATION METHOD WITH WAXING IRON

- Drip the paraffin lump onto the base by placing it in contact with the base of the waxing iron at a temperature of 130°C.
- Then spread the wax in a regular forward and backward movement and finally make a continuous pass from tip to tail at a constant speed (approx. 2 cm per second).
- 2.b (mix with GREEN powder) On the layer of HP3 RED just melted spread a layer of GREEN powder (the quantity depends on how new and abrasive the snow is to preserved crystal and/or artificial snow) and with the waxing iron at 130°C. perform a continuous pass from tip to tail at low speed (about 1cm. per second) perfectly melting the powder in the underlying solid paraffin.
- Wait at least 15 minutes to allow the wax to solidify and the base to cool;
- Remove excess wax with a well-sharpened Plexiglas spatula, exerting little pressure;
- Remove the solidified paraffin from the side of the ski and the side of the edges;
- Free the impression with a stiff nylon hand brush;
- Brush the impression with a manual or rotating stiff horsehair brush;
- Polish the impression with hand brush or rotating soft nylon brush.